Active Vocabulary. Removal and installation

REMOVAL AND INSTALLATION

THE CENTRAL INJECTION UNIT

TEXT 2

Active Vocabulary

technological preparedness - техническая готовность	maintenance - обслуживание
technical defects - технические неисправности	labour productivity – производительность труда
mechanize – механизировать	financial expenses – финансовые издержки, расходы
rubbing surface – трущаяся поверхность	work surface – рабочая поверхность
coaxiality – соосность	engine – двигатель, мотор
exceeding – чрезмерный, безмерный	heat mode – тепловой режим
cooling system – охлаждающая система	combustion chamber – камера сгорания
absorbing manifold – всасывающий трубопровод	warping – коробление
crankpin – шатунная шейка	main journal – коренная шейка
crankshaft – коленчатый вал	limiting wear - предельный износ
planned-precaution system – планово-предупредительная система

Establish the lever of transfer switching in a neutral position and brake the automobile by a lay brake.

As after a stop of the engine the pressure of fuel in the power supply system is kept, first of all it is necessary to reduce pressure. For this purpose disconnect shoe of wires twist of injection system from shoes of electric pump wires. Start the engine and leave it to work for three seconds for reduction of pressure in a fuel conductor. Connect back wires of electric pump to twist of wires of injection system.

Disconnect a wire from the plug «minus» of the storage battery.

Remove the air filter and disconnect a cable of a throttle lid drive from the central injection unit.

Disconnect fuel conductor from the central injection unit and close the ends of the pipes fuel conductors with fuses for inadmissible flow of fuel.

Disconnect electrical wires from the gauge of a throttle lid, injectors and regulator.

Remove branch pipes of vacuum hoses of the central injection unit going to absorber and the gauge of absolute pressure, and also to the hose of system of crankcase ventilation of the engine. Pay attention to correctness of their connection at the subsequent assembly.

Unscrew fastening tacks; also remove the central injection unit from an inlet pipe. Close an entrance aperture of the inlet pipe with muffle.

Installation of the central injection unit is carried out in the return order. Thus pay attention to a condition of linings.

Check up pressure of fuel submission after installation.

establish-установить	central injection-центральный впрыск
disconnect-отсоединять	ring-кольцо
pressure-давление	fuel-топливо
pipelines-трубопроводы	storage battery-аккумуляторная батарея
regulator-регулятор	electric pump-электронасос
plug-клемма	submission-подача
cable-трос	hoses-шланги
wires-провода

Дата добавления: 2014-10-17