Maintenance Procedure. Headlight Beam Vertical Adjustment

NOTE

Headlight Beam Vertical Adjustment

Headlight Beam Horizontal Adjustment

• Insert the conventional screwdriver into the adjuster from
underside of the headlight, turn the horizontal adjuster [A]
on the headlight housing in or out until the beam points
straight ahead. Turning the adjuster clockwise moves the
headlight beam to the left.

• Insert the conventional screwdriver into the adjuster from
the slit of the meter cover, turn the vertical adjuster [B]
on the headlight housing in or out to adjust the headlight
vertically.

○On high beam, the brightest point should be slightly be­low horizontal with the motorcycle on its wheels and rider seated. Adjust the headlight to the proper angle according to local regulations.

Side Stand Switch Operation Inspection

• Inspect the side stand switch [A] operation in accordance
to below table.

Sidestand Switch Operation

Side Stand	Gear Position	Clutch Lever	Engine Start	Engine Run
Up	Neutral	Released	Starts	Continue running
Up	Neutral	Pulled in	Starts	Continue running
Up	In Gear	Released	Doesn’t start	Continue running
Up	In Gear	Pulled in	Starts	Continue running
Down	Neutral	Released	Starts	Continue running
Down	Neutral	Pulled in	Starts	Continue running
Down	In Gear	Released	Doesn’t start	Stops
Down	In Gear	Pulled in	Doesn’t start	Stops

• If the side stand switch operation does not work, inspect or replace the following item. Battery (see Battery Activation in the Electrical System chapter)

Main Fuse 30 A (see Fuses in the Electrical System chapter)

Ignition Fuse 10 A (see Fuses in the Electrical System chapter)

Ignition Switch (see Switch Inspection in the Electrical System chapter)

Side Stand Switch (see Switch Inspection in the Electri­cal System chapter)

2-38 Периодический ремонт

Engine Stop Switch (see Switch Inspection in the Elec­trical System chapter)

Starter Button (see Switch Inspection in the Electrical System chapter)

Starter Relay (see Starter Relay Inspection in the Elec­trical System chapter)

Junction Box (see Junction Box Inspection in the Elec­trical System chapter)

Harness (see Wiring Inspection in Electrical System chapter)

• If the all parts are good condition, replace the IC igniter.

Engine Stop Switch Operation Inspection

Дата добавления: 2014-12-23