Carburetors

Fuel spilled from the carburetors is hazardous.

WARNING

Install the clamp screws horizontally as shown. Otherwise the screws could come in contact with the vacuum adjusting screws, resulting in an un­safe riding condition.

[C] Top

[D] Bottom

• Check fuel leakage from the carburetors.

• Adjust the following items if necessary. Idle Speed

Vacuum Synchronization Throttle Cables

Service Fuel Level Inspection

WARNING

Gasoline is extremely flammable and can be ex­plosive under certain conditions. Turn the ignition switch OFF. Do not smoke. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light

• Situate the motorcycle so that it is perpendicular to the ground.

• Connect a suitable rubber hose (5 mm inside diameter and about 300 mm long) to the fitting at the bottom of each carburetor float bowl.

3-12 Топливная система

• Connect fuel level gauge [A] to the rubber hose.

Special Tool - Fuel Level Gauge: 57001-1017

• Hold the gauge vertically against the side of the carburetor body so that the "middle" line [B] is several millimeters higher than the bottom edge [D] of the carburetor body.

• Turn the fuel tap to the PRI position to feed fuel to the carburetor, then turn out the carburetor drain plug [C] a few turns.

• Wait until the fuel level [E] in the gauge settles.

• Keeping the gauge vertical, slowly lower the gauge until the "middle" line is even with the bottom edge of the car­buretor body.

Дата добавления: 2014-12-23