Intake camshaft bearing cap bolt tightening sequence - 1.3 litre

A Align the exhaust camshaft gear with the intake camshaft gear by matching up the timing marks on the gears

Wipe off the oil and inspect each follower for wear and scuffing

A Remove the circlip with a pair of circlip pliers

2A•14 Engine in-car repair procedures

are snug with the cylinder head. Do not tighten the bolts to the full torque setting at this stage.

24 Apply moly-base grease or engine assembly lube to the exhaust camshaft followers, then install them in their original locations. Make sure the valve adjustment shims are in place on the followers.

25 Apply moly-base grease or engine assembly lube to the exhaust camshaft lobes and bearing journals.

3 Align the exhaust camshaft gear with the intake camshaft gear by matching up the timing marks on the gears (see illustration). On some 1.3 litre engines there are two sets of timing marks - DO NOT use the timing marks for the S engines when installing the camshafts and gears (see illustration).

4 Roll the exhaust camshaft down into position. Turn the intake camshaft back-and-forth a little until the exhaust camshaft sits in the bearings evenly.

Дата добавления: 2014-12-23