Removal. B . then release the clips and disconnect the heater hoses from the bulkhead stubs

B... then release the clips and disconnect the heater hoses from the bulkhead stubs

To prevent accidental deployment (and possible injury),turn the ignition key to LOCK and disconnect the negative battery cable whenever working near airbag components. After the battery is disconnected, wait at least two minutes before beginning work

Refitting

6 Refitting is the reverse of removal. Check for proper operation.

10 Heater matrix -removal and refitting

Warning: These models are equipped with airbags. The airbag is armed and can deploy (inflate) anytime the battery is connected.

(the system has a back-up capacitor that must fully discharge). For more information see Chapter 12.

1 Have the air conditioning refrigerant discharged (where applicable) by an automotive air conditioning specialist.

2 Disconnect the negative cable from the battery (see Chapter 5A).

3 Drain the cooling system (see Chapter 1), unless you have access to hose clamps (see next paragraph).

4 Working in the engine compartment, release the clips and disconnect the heater hoses at the bulkhead. If you have access to hose clamps, use them on the heater hoses - then there's no need to drain the coolant (see illustrations). Recover the rubber grommetfrom the bulkhead.

Дата добавления: 2014-12-23