Trial run (adjusting the force and tool)

Installation of the cutting media

1 Loading the cutting media

1. Lift the pinch-roller handles and let it away from the metal rollers.

2. Insert the vinyl between metal rollers and pinch rollers of the machine from behind to front.

3. Carefully check the vinyl before cutting, since if vinyl is not well placed, serious deviation will occur. If the vinyl is uneven lift the pinch rollers on one side to adjust and then press down pinch rollers. It is necessary to trial-run the vinyl several times to attain minimum deviation before cutting work.

2 Adjust the place of pinch rollers according to paper width

Cutting plotter has 2 to 4 pinch rollers and they can be moved along the guide rail. The handles of pinch rollers must be lifted before moving pinch rollers, hold the back of the roller and push it to the left or the right. Please donЎЇt pull the roller bars in the front, otherwise the machine precision will be affected.

3 The place of the rollers must ensure:

1.Pinch rollers should be in the place out of the scope of the pattern.

2.Pinch rollers should be 10 to 50mm away from the edges of the paper.

3.Pinch rollers shouldnЎЇt be let down on the conjunction of two connecting metal rollers.

1 Test Cut

Once the blade/plotter is installed and the vinyl is inserted, preliminary test-cut should be carried out to check the force of the blade/plotter if it is acceptable. To do so, press the TEST key. and shows as following. Then the machine will automatically cut a pattern

2 Force Adjustment

Take off the cutted pattern, if you fail, the pattern need to be further cut, because the force is too low or the protruding length of the blade top is too short. If the base paper is pierced through, it signifies that the protruding length of the blade top is too long and the force is too big. The protruding portion of the blade tip should be about 0.5mm or less in length normally which is 2/3 of the thickness of vinyl. Adjust the protruding length of the blade top and forcess according to result of test

By pressing F+ or F- the force of the blade will be increased or decreased by one level..

Caution:

Дата добавления: 2014-12-23