Removal. A Remove the two screws in the

A Remove the two screws in the

heater knob recesses (arrowed)...

11 Heater and air conditioning control assembly -removal and refitting

1 Remove the rear section of the centre console (see Chapter 11).

2 Pull off the control knobs, and the air recirculation knob.

3 Undo the two screws in the knob recesses, the carefully pull away the centre cluster finish panel. Disconnect the wiring plugs as the panel is removed (see illustrations).

4 Pull up the driver's door sill trim panel, remove the footwell kick panel, then undo the two bolts and remove the lower facia panel under the steering column (see illustration). Disconnect the bonnet release cable if required.

5 Undo the two screws and remove the metal shield (where fitted) from underneath the steering column (see illustration).

6 Prise out the clip and remove the right-hand side heater ducting from under the steering column.

7 Release the clip either side and pull the control out slightly.

8 Disconnect the control cable (black) from the heater control valve in the engine compartment, adjacent to the bulkhead (see illustration).

9 Working through the ashtray aperture, disconnect the temperature control cable (blue) from the rear of the heater housing.

10 Remove the glovebox as described in Chapter 11, Section 27.

11 Disconnect the heat distribution cable (grey) from the linkage at the right-hand side of the heater housing (see illustration).

12 Disconnect the recirculation control cable (yellow) from the left-hand side of the heater housing.

13 Pull the control unit outwards then disconnect the wiring plugs and remove the control unit (see illustration).

Дата добавления: 2014-12-23