Train Loading

Round Trip Time

Once the patronage is determined, the train service has to be planned to carry the people who turn up. During the peak hours, this can be a lot of people. The frequency and number of trains required has to be calculated to match. First the run times are worked out, again by a computer program which includes the profile of the line (curves, gradients, station locations, dwell times at stations etc.) and the performance of the trains to be used. On heavily used lines, the program may incorporate the patronage figures to estimate the number of seconds each train has to stand or "dwell" at each station while loading and unloading takes place.

The diagram of our imaginary Forest line above shows in red the computer generated arrival times, in seconds, for a train running in each direction. Added together and with allowances for terminal standing times, the program will eventually provide a "round trip time", i.e the time it takes to run from one end of the line to the other, wait at the terminus, run back to the starting place and wait for the next round trip departure time.

In our example above, the run time from Ash to Plane is 869 seconds and the time back from Plane to Ash is 871 seconds. There is a 120 second dwell at each terminus to allow the train to change direction and load/unload passengers. This is actually longer than needed but we usually leave in a bit of extra time for delays - known as "recovery time". This time is also used to give a round trip time to balance the service interval. The end result - our round trip time - is 1980 seconds or 33 minutes.

The next step is the train loading. First we determine the train capacity - in our example above, I have used a capacity of 700 passengers. This is a fairly small number for a modern metro line but it is used in London for some lines and for those places which have short trains. At the other end of the scale, in Hong Kong, the Kowloon Canton Railway uses over 4000 passengers per train as the planned capacity of its 12 car trains. On one occasion, 363 passengers were counted travelling in one 24 metre car.

The density of passengers also determines the total capacity. In Western countries, the standing capacity of a train will often be calculated at 4 or 5 passengers per sq./m. In the Asian context, this number rises to 8 per sq./m. Europeans want lots of space, Asians don't seem to mind so much. The standing area is the free floor area of the car, i.e. where there are no seats.

We also decide on a load factor. No train will fill with passengers equally from end to end and passengers will not arrive at stations in steadily flowing numbers throughout each hour. So, a load factor is applied. In our case, it is 85%, a relatively small allowance used in Hong Kong because of the density of traffic. Larger allowances may be appropriate in other countries.

Now we know the capacity of the train (700 * 85% = 595), it is a relatively simple sum to use the patronage data to determine the number of trains required each hour. You divide the numbers of passengers travelling along the busiest section of line (11,500) by the train capacity (595) to get trains per hour (19.32). We have to call it 20 trains per hour as we can't run 0.32 of a train. Twenty trains per hour is equivalent to a train every three minutes or a 3-minute headway.

Дата добавления: 2014-01-11