Exercises. I. Use the following wards and phrases in sentences of your own:

I. Use the following wards and phrases in sentences of your own:

round thread, internal thread, triple thread, profiles of thread, triangular thread, square thread, buttress thread, pitch of thread, right-hand thread, screw thread, single thread, left-hand thread

II. Retell the text giving answers to the following questions:

1. What are threads used for? 2. What types of threads do you know? 3.What are the main elements of a thread? 4. What types of screw threads do you know? 5. What are the most widely used systems of triangular threads in machine-building?

III. Find in the text synonyms of the following words and word combinations:

square thread, trapezoidal thread, major diameter, minor diameter, root diameter

IV. Analyse and translate the following sentences:

1. The metal cannot be compressed, but is cold forged into a different form, and what takes place when the thread shaped dies are forced into the metal to form a thread is displacement of the surface which is forced into grooves, that is, the material from the depressions forms the elevations on either side. 2. The V-shaped thread must not be made sharp because the sharp crest of the V-thread is very easily broken, and the taps and dies will not stand long due to the sharp thread. 3. The finished thread is of greater diameter than the original diameter of the wire, which in turn is larger than the diameter of the finished thread at the root. 4. A screw or bolt of a given size has a greater minor diameter and a greater strength if the pitch is fine rather than coarse. 5. The finished product is therefore larger in diameter than the blank by an amount approximately equal to the depth of the thread. 6. This process of rolling threads, grooves and screw blanks is used in the manufacture of many articles in preference to cutting the threads or grooves with ordinary slow-cutting tools or threading dies.

V. Make up as many questions as possible concerning the following sentences:

1. During the operation the metal is cold forged into a different form. 2. The finished thread is of greater diameter than the original diameter of the wire. 3. A crest of a thread is the top surface joining the two sides of the thread. 4. A base of a thread is the bottom surface joining the two adjacent threads. 5. In screw fastenings threads are made of triangular type.

VI. (a) Read and translate the following text using a dictionary:

The process of rolling screw threads has been greatly developed and its usefulness extended by the rather recent introduction into common use of a material suitable for roll threading. Iron of ordinary quality does not lend itself well to this process on account of its fibrous structure, which makes this material liable to split or fracture under pressure, but in the modern low-carbon steel we find a material in

every way suited to the rapid and economical forming of screw threads. By this process the blank is rolled between two flat dies with their working surfaces grooved to the shape of the thread required, these grooves being cut across the face of the dies at the proper angle to suit the pitch and diameter of the screw.

(b) Retell the text.

VII. On the basis of Fig. 38 describe what profiles of thread are obtained depending on the shape of the threading tool.

VIII. Giving answers to the following questions describe the main elements of a thread as shown in Fig. 34:

l. What are the main elements of a thread? 2. What is the angle included between the sides of the thread called? 3. What is the distance between the two extreme outside points of the thread in the direction square to the axis called? 4. What is the largest diameter of a thread called? 5. What is the minor diameter of a thread? 6. What is called the "pitch diameter" of a thread? 7. What is the distance from a point of thread to the corresponding point on the next thread measured to, the axis called? 8. What is the depth of a thread?

IX. Describe the shapes of threads in screw fastenings on the basis of Fig, 35.

Дата добавления: 2014-12-27