Immediately wipe up any brake fluid that spills. Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc

Master Cylinder

BRAKES

Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc. The brake will not function on the first application of the lever if this is not done.

WARNING

Rear Master Cylinder Removal • Remove the right side cover. Remove the muffler cover bolts [A] and muffler cover [B].

• Pull out the cotter pin [A] from the pin [B] fixing the pin so that it does not turn, and remove the pin.

CAUTION

• Remove the reservoir mounting bolt [A].

• Remove the brake hose banjo bolt [B].

• Remove the rear master cylinder mounting bolts [C] and pull up the master cylinder with the reservoir tank.

Rear Master Cylinder Installation

• Install the removed parts in order to the reverse of re­moval.

• Install the new cotter pin and bend it the end of itenoughly after connecting the connecting rad and pin.

Torque - Brake Hose Banjo Bolt: 34 N·m (3.5 kgf·m, 25 ft·lb) Rear Master Cylinder Mounting Bolts: 25 N·m (2.5 kgf·m, 188 in·lb)

• Bleed the brake line after master cylinder installation (see
Bleeding the Brake Line).

И

Дата добавления: 2014-12-23