Position the No 1 cylinder camshaft lobes away from the followers

Intake camshaft bearing cap bolt tightening sequence - 1.6 litre

Use the installation marks, NOT the timing marks

Exhaust camshaft bearing cap bolt tightening sequence - 1.6 litre

Apply sealant to the shaded areas of the exhaust camshaft bearing cap

2A•16 Engine in-car repair procedures

	85 Align the camshaft sprocket timing
	marks (see illustration 3.7b), then rotate
	the crankshaft 90° clockwise, back to TDC
	position (with the crankshaft key upright in the
	12 o'clock position).
	86 Refit the timing chain	as described in
	Section 6.
	11 Cylinder head-
	removal and refitting
10.79 Lift the followers from position	Note: The engine must be	completely cool
	before beginning this procedure.

in numerical order with the arrows pointing toward the timing belt end of the engine.

70 Following the recommended sequence

(see illustration), tighten the bearing capbolts in 1/4-turn increments to the torque listed in this Chapter's Specifications.

71 Remove the service bolt from the intake camshaft gear.

72 Install the timing belt sprocket on the exhaust camshaft and tighten the bolt to the torque listed in this Chapter's Specifications. Prevent the camshaft from turning by holding it with a spanner on the hexagonal section.

73 Install the timing belt (see Section 5).

74 The remainder of refitting is the reverse of the removal procedure.

Дата добавления: 2014-12-23