Depress the clip and disconnect the sender unit wiring plug

Connect an ohmmeter to the sender unit terminals

Denso manufactured

28 Remove the fuel tank cap.

29 Disconnect the cable from the negative terminal of the battery (see Chapter 5A).

30 Remove the rear seat cushion, and lift the carpet underneath it (see Chapter 11).

31 Using a flat-bladed tool, carefully prise up the fuel pump/sender unit access cover (see illustration 3.4).

32 Disconnect the electrical connector, and disconnect the fuel pipe(s) (see illus-trations 3.5a, 3.5b and 3.5c).

33 Unscrew the sender unit plastic retaining collar using a pair of large, crossed-screwdrivers, or improvise a tool (see illustration 3.46). Make alignment marks

between the collar and the tank to aid refitting.

34 Carefully lift the sender/pump assembly from position.

35 Carefully prise off the plastic bracket at the base of the assembly, and remove the rubber cushion.

36 Pull the fuel pressure regulator from place, and recover the O-ring.

37 Remove the clip and withdraw the filter from the base of the pump.

38 Release the clips securing the top 'suction plate' of the assembly, then disconnect the fuel pump connector. Recover the O-ring seal.

39 Pull the fuel pump from position.

40 Refitting is the reverse of removal. On vehicles where the pump/sender assembly is retained by a locking collar, the collar must be tightened up to the same point as before disassembly.

Дата добавления: 2014-12-23