CHK ADJ. • Check the steering head for looseness or binding by turning it all the way in both directions

E-1

CHK ADJ

Do not over-tighten

• Check the steering head for looseness or binding by turning it all the way in both directions. If it binds, remove the steering stem assembly and check the steering bearings

See STEERING HEAD in Chapter 7

• Install the rubber washer

• Install the rubber nut (centre) Ø

• Finger-tighten the ring-nut (centre), then align the slots of both ring nuts. If necessary, hold the ring-nut

(lower) Ø and tighten the ring-nut (centre) Ø until

their slots are aligned

CHECKING THESTEERING HEAD/ CHECKING THE FRONT FORK

CHECKING THE SWINGARM/REAR SHOCK ABSORBER/ADJUSTING THE REAR SHOCK ABSORBER

• Install the lock washer

NOTE:

Ensure that the lock washer tabs sit correctly in the ring nut slots

• Hold the ring-nuts (under and centre), using the exhaust and ring-nut wrench, and tighten the ring- nut (upper) using the ring-nut wrench

75 Nm (7,5 m • kg)

Дата добавления: 2014-12-23