Checking the rear shock absorber

Support the scooter so that it cannot fall over

CHECKING THE SWING-ARM

1. Place the scooter on a flat surface

2. Check:

• That it works properly

Grasp the end of the swing-arm and gently rock the swing-arm assembly back and forth

If it does not do so smoothly, repair it

See section on REAR SHOCK ABSORBER AND SWINGARM in Chapter 7

************************************************************

6. Install:

• Upper front panel

CHECKING THE FRONT FORK

s WARNING:

1. Stand the scooter on a level surface 2.Check:

• Inner tube

If there are any scratches or damage, replace it

• Oil seal

Replace if there is excessive leakage of oil

Hold the scooter upright and apply the front brake

3. Check:

• That it works properly

Push down hard on the handlebars several times If it does not work smoothly, repair it

See FRONT FORK in Chapter 7

1

b a

1. Check:

• Rear shock absorber mount Tighten up where necessary Bolt (upper)

32 Nm (3,2 m•kg)

Screw (lower)

35 Nm (3,5 m•kg)

See section on REAR SHOCK ABSORBER AND SWINGARM in Chapter 7

Дата добавления: 2014-12-23