Marks Stamped on the Cutter

NOTE

NOTE

Seat Cutter Operating Cares

Valves

ENGINE TOP END

57001-1113 57001-1118 57001-1328 57001-1125 57001-1128

57001-1187 57001-1120 57001-1123

Valve Seat Cutter Holder - 05.5 Valve Seat Cutter Holders Bar

Seat Cutter

Seat Cutter

Seat Cutter

Exhaust Valve

Seat Cutter

Seat Cutter

Seat Cutter

Special Tools -Inlet Valve

45°-030.0 32°-030.0 60°-030.0 45°-024.5 32°-025.0 60°-025.0

• If the manufacturer’s instructions are not available, use the following procedure.

1. This valve seat cutter is developed to grind the valve for repair. Therefore the cutter must not be used for other purposes than seat repair.

2. Do not drop or shock the valve seat cutter, or the dia­mond particles may fall off.

3. Do not fail to apply engine oil to the valve seat cutter before grinding the seat surface. Also wash off ground particles sticking to the cutter with washing oil.

O Do not use a wire brush to remove the metal particles from the cutter. It will take off the diamond particles.

4. Setting the valve seat cutter holder [A] in position, oper­
ate the cutter [B] in one hand [C]. Do not apply too much
force to the diamond portion.

OPrior to grinding, apply engine oil to the cutter and dur­ing the operation, wash off any ground particles sticking to the cutter with washing oil.

5. After use, wash the cutter with washing oil and apply a
thin layer of engine oil before storing.

• The marks stamped on the back of the cutter [A] represent

Cutter angle [B] Cuter diameter of cutter [C]

the following. 60° 37.50

Дата добавления: 2014-12-23