ELECTRICAL SYSTEM

NOTE

CAUTION

Quick Charge

Battery

Refreshing Charge

и

WARNING

This battery is sealed type. Never remove seal cap [B] even at charging. Never add water. Charge with current and time as stated below.

• Disconnect the battery terminals (see Charging Condition Inspection).

• Remove the battery [A].

• Do refresh-charge by following method according to the battery terminal voltage.

Terminal Voltage: 11.5 ~ less than 12.8 V Standard Charge

1.2A×5~10h (see following chart)

5.0 A × 1.0 h

If possible, do not quick charge. If the quick charge is done due to unavoidable circumstances, do stan­dard charge later on.

 

Terminal Voltage: less than 11.5 V Charging Method 1.2 A × 20 h

○If the current does not flow when charging, raise the voltage initially (25 V as maximum), and let down the voltage to charge when the current starts to flow as a yardstick. If ammeter shows no change in current after 5 minutes, you need a new battery. The current, if it can flow into the battery, tends to become excessive. Adjust the voltage as often as possible to keep the current at standard value (1.2 A).

Battery [A] Battery Charger [B] Standard Value [C] Current starts to flow [D]

•_○DDeetteerrmmiinnee bthaettecroyncdoitniodnitioonf tahfetebr arettfererysh3in0gmcihnaurtgees.after

completion of the charge by measuring the terminal volt­age according to the table below.