CAUTION. Yuasa 1.5 Amp Automatic Charger

NOTE

Battery Mate 150-9

Yuasa 1.5 Amp Automatic Charger

Initial Charge

NOTE

Battery

ELECTRICAL SYSTEM 16-21

• Gently remove the container from the battery.

• Let the battery sit for 60 minutes prior to charging to allow the electrolyte to permeate into the plates for optimum performance.

OCharging the battery immediately after filling can shorten service life. Let the battery sit for at least 60 minutes after filling.

• Place the strip [A] of caps loosely over the filler ports.

• Newly activated sealed batteries require an initial charge.

Standard Charge 1.2 A × 5-10 hours

• If using a recommended battery charger, follow the
charger’s instructions for newly activated sealed battery.

Kawasaki-recommended chargers: Optimate III

• If the above chargers are not available, use equivalent
one.

OCharging rates will vary depending on how long the battery has been stored, temperature, and the type of charger used. Let battery sit 30 minutes after initial charge, then check voltage using a voltmeter. If it is not at least 12.8 volts, repeat charging cycle.

• After charging is completed, press down firmly with both
hands to seat the strip of caps [A] into the battery (don’t
pound or hammer). When properly installed, the strip of
the caps will be level with the top of the battery.

Once the strip of the caps [A] is installed onto the battery, never remove the caps, nor add water or electrolyte to the battery.

Дата добавления: 2014-12-23