Battery

ELECTRICAL SYSTEM 16-19

Electrical Wiring

ELECTRICAL SYSTEM

Precautions

ELECTRICAL SYSTEM 16-17

Male Connectors [B]

Wiring Inspection

• Visually inspect the wiring for signs of burning, fraying, etc.

• If any wiring is in poor condition, replace the damaged wiring.

• Pull each connector [A] apart and inspect it for corrosion, dirt, and damage.

• If the connector is corroded or dirty, clean it carefully. If it is damaged, replace it.

• Check the wiring for continuity.

OUse the wiring diagram to find the ends of the lead which

is suspected of being a problem. OConnect an ohmmeter between the ends of the leads. OSet the meter to the × 1 Q range, and read the meter.

• If the meter does not read 0 Q, the lead is defective. Re­
place the lead or the wiring harness [B], [C] if necessary.

Battery Removal/Installation

• Remove:

Seat (see Seat Removal in the Frame Chapter)

• Remove the rubber IC igniter cover [A] with the igniter connected.

• Remove the battery pusher [B] by taking off the bolt [C] and nut [D].

• Remove the negative (–) lead [A] from the battery first.

• Remove the positive (+) lead [B] from the battery and pull out the battery.

• When installing, connect the positive (+) lead first [A], then the negative (–) lead [B] to the battery.

Battery Activation

Дата добавления: 2014-12-23