Ignition System. IC Igniter Operation Voltage Check

ELECTRICAL SYSTEM

IC Igniter Operation Voltage Check

NOTE

OFollow the instructions in the manufacturer’s operation manual for the proper procedure for operating the ig­niter checker.

OThe igniter checker can perform inspections by simu­lating the following dynamic characteristics: the igniter response in relating to the engine speed, interlock cir­cuit signals, tachometer signals, and engine overspeed limiter signals.

OThe igniter checker cannot be used for inspecting the conditions of the CDI unit.

• If the igniter is defective, replace it.

• Remove the seat (see Seat Removal in the Frame chap­
ter).

Disconnect the IC igniter connector [A].

• Set the Hand Tester [A] to the × 25 V DC range, and
connect it to the connector come from harness side as
follows.

Tester (+) terminal [B] —► BR/W lead Tester (-) terminal [C] —► BK/Y lead

Special Tool - Hand Tester: 57001-1394

Needle Adapter Set: 57001-1457

• Turn the ignition switch on, and read the voltage.

IC Igniter Operation Voltage: Battery Voltage

• If the tester reading is not specified one, check the battery
voltage, ignition switch and ignition fuse.

Дата добавления: 2014-12-23