Every 32 000 km or 2 years

VVT-i models -

Every 30 000 km or 2 years

Non-VVT-i models -

Brake fluid renewal

Every 30 000 km or 2 years

Non-VVT-i models -

Note: This procedure applies only to the non-VVT-i engine models

1 The canister filter is mounted in a bracket on the engine compartment bulkhead near the left side of the car.

2 Remove any components that would interfere with access to the top of the filter.

3 Using a second spanner to steady the filter, remove the threaded banjo bolt at the top and loosen the fitting at the bottom of the fuel filter

(see illustrations).

4 Remove both bracket bolts from the bulkhead and remove the old filter and the filter support bracket assembly.

5 Note that the inlet and outlet pipes are

clearly labelled on their respective ends of the filter and that the flanged end of the filter faces down. Make sure the new filter is installed so that it's facing the proper direction as noted above. When correctly installed, the filter should be installed so that the outlet pipe faces up and the inlet pipe faces down.

6 Using the new crush washers provided by the filter manufacturer, install the inlet and outlet fittings and tighten them securely.

7 The remainder of installation is the reverse of the removal procedure.

Warning: Brake hydraulic fluid can harm your eyes and damage painted surfaces, so use extreme

Дата добавления: 2014-12-23