Cylinder head mot

F-4

CYLINDER HEAD ENG

ENGINE REMOUNTING ENG

F-3

ENGINE OVERHAUL ENG

HOSES, AIR FILTER CASE, ENGINE MOUNTING BOLT AND ENGINE

ENGINE REMOUNTING

When remounting the engine, reverse the removal procedure.

Note the following points:

1. Install:

• Engine Ø

• Swing-arm bolt Ø

• Nut Ø

Order	Job name/part name	Quantity	Remarks
	Wire hoses, air filter case,		Remove the parts in the order shown
engine mounting bolt and engine
Vacuum hose
	Starter cable
	Inlet hose (water pump)
	Heater cable
	Outlet hose (thermostat)
Swing-am bolt		(Rear shock absorber lower)
Nut
Screw
Engine
When reassembling reverse the
order followed when stripping-down.

Order	Job name/part name	Quantity	Remarks
	Exhaust Water pump Bypass hose Timing chain tension assembly Timming chain tension gasket Cam sprocket/ timing chain Cylinder head Cylinder head gasket Dowel pin	1/1 1/1 1/1 1/1
		See section on CYLINDER HEAD REMOVAL AND INSTALLATION
	When reassembling reverse the order followed when stripping-down.

CYLINDER HEAD CYLINDER HEAD

Order	Job name/part name	Quantity	Remarks
	Wire Cylinder head		Remove the parts in the order shown
Seat and compartment
Drain coolant
Remove filter case
Remove carburttor	See section on CARBURETTOR in
	Chapter 6
Thermostat lead
	Plug cap
	Breathing hose (water pump)
	Outlet hose (cylinder head)
	Vacuum hose
	Inlet hose (pump)
	Water outlet hose
	Carburettor joint
Rubber ignition lid stopper

Дата добавления: 2014-12-23