Carburetors. О Do not lower the middle line below the bottom edge of the carburetor body

WARNING

NOTE

О Do not lower the "middle" line below the bottom edge of the carburetor body. If the gauge is lowered and then raised again, the fuel level measured shows somewhat higher than the actual fuel level. If the gauge is lowered too far, dump the fuel out of it into a suitable container and start the procedure over again.

• Read the fuel level in the gauge and compare it to the specification.

• Screw in the carburetor drain plug.

Fuel Level 1.5 mm (0.06 in.) above ~ 0.5 mm (0.02 in.) below the bottom edge of carburetor body

• Turn the fuel tap to the ON position and remove the fuel level gauge.

• Inspect the fuel level in another carburetor in the same manner.

• If the fuel level is incorrect, adjust it (see Service Fuel Level Adjustment).

Service Fuel Level Adjustment

Gasoline is extremely flammable and can be ex­plosive under certain conditions. Turn the ignition switch OFF. Do not smoke. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light.

• Remove the carburetor, and drain the fuel into a suitable container.

Топливная система 3-13

• Remove the float bowl by taking out the float chamber screws [A] and water hose fitting screws [B] with lock-washers.

Slide out the pivot pin [A] and remove the float [B].

• Bend the tang [A] on the float arm very slightly to change the float height. Increasing the float height lowers the fuel level and decreasing the float height raises the fuel level.

Float Height 17.0 ±2.0 mm (0.67 ±0.08 in.)

Дата добавления: 2014-12-23