Hub Bearing

NOTE

Rear

Front

Do not lay the wheel on the ground with the disc facing down. This can damage or warp the disc. Place blocks under the wheel so that the disc does not touch the ground.

CAUTION

Hub Bearing

Hub Bearing Removal Remove the wheel, and take out the following.

Grease Seal [A] Circlips [B]

Special Tool - Inside Circlip Pliers: 57001-143

Coupling [A] Collar [B] Circlip [C]

Special Tool - Inside Circlip Pliers: 57001-143

• Take the bearings [A] out of the hub, using the bearing remover.

Special Tools-Bearing Remove Shaft: 57001-1377 [B]

Bearing Remover Head, 015 × 1 7: 57001

-1267 [C] Oil Seal & Bearing Remover: 57001-1058

Hub Bearing Installation

• Before installing the hub bearings, blow any dirt or foreign particles out of the hub with compressed air to prevent contamination of the bearings.

• Replace the bearings with new ones.

•_○IPnrsetsasll itnhethferolnetftbseidaerinbgesairnintghe[Af]oullonwtilinitgissbeoqtutoemnceed..

○Insert the collar [B] in the hub [C].

○Press in the right side bearing [D] until it is bottomed.

Special Tool - Bearing Driver Set: 57001-1129

•_○IPnrsetsasll itnhethreearirgbhet asridinegbseinartihneg fuonlltoilwitinisgbsoetqt oume necde..

○Insert the collar in the hub.

○Press in the left side bearing until it is bottomed.

Special Tool - Bearing Driver Set: 57001-1129

○Install the bearings so that the marked side or sealed side faces out.

• Replace the circlips with new ones.

Special Tool - Inside Circlip Pliers: 57001-143

WHEELS/TIRES 10-13

Hub Bearing Inspection

Since the hub bearings are made to extremely close tol­erances, the clearance cannot normally be measured.

Дата добавления: 2014-12-23