Wheels (Rims). Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc

Do not attempt to drive the motorcycle until a full brake lever is obtained by pumping the brake lever until the pads are against the disc. The brake will not function on the first application of the lever if this is not done.

A WARNING

WHEELS/TIRES 10-7

Rear Wheel Removal

• Remove:

Rubber Cap

Cotter Pin [A]

Rear Axle Nut [B] (loosen)

• Raise the rear wheel off the ground using the jack.

Special Tool - Jack: 57001-1238

• Remove:

Rear Axle Nut and Washer Indicators [C]

• Pull out the rear axle to the right and drop the rear wheel holding the rear brake caliper with caliper holder on the swingarm so that the rear caliper does not tall.

• Remove the drive chain [A] from the rear sprocket toward the left. Move the rear wheel [B] back and remove it.

Rear Wheel Installation

• Engage the drive chain with the rear sprocket.

• Fit the rear brake caliper to the brake disc.

• Hold the rear brake caliper holder aligning the holder stop [A] to the swing arm stop [B], and insert the axle from the right side of the wheel through both indicators and adjusters.

• Spin the wheel, and apply the rear brake, and then tighten
the axle nut to the specified torque.

Torque - Rear Axle Nut: 108 N-m (11 kgf-m, 80 ft-lb)

• Check the drive chain slack and adjust it if necessary.
Install the removed parts.

10-8 WHEELS/TIRES

Дата добавления: 2014-12-23