Relay Circuit Inspection (with the battery disconnected)

ELECTRICAL SYSTEM 16-63 Junction Box

Fuse Circuit Inspection

Junction Box

ELECTRICAL SYSTEM

The junction box [A] has fuses [B], relays, and diodes. The relays and diodes can not be removed.

Junction Box Fuse Circuit Inspection

• Remove the left side cover (see Side Cover Removal in the Frame chapter).

Remove the junction box.

Pull off the connectors from the junction box.

• Make sure all connector terminals are clean and tight, and none of them have been bent.

• Clean the dirty terminals, and straighten slightly-bent ter­minals.

• Check conductivity of the numbered terminals with the hand tester.

• If the tester does not read as specified, replace the junc­tion box.

Special Tool - Hand Tester: 57001-1394

Tester Connection	Tester Reading (Ω)	Tester Connection	Tester Reading (Ω)
1 - 1A		1A - 8	ОО
1-2		2-8	ОО
3A - 4		3A - 8	ОО
6-5		6-2	ОО
6 - 10		6 - 3A	ОО
6-7		17 - 3A	ОО
6 - 17

Starter Circuit/Headlight Relay Inspection

• Remove the left side cover (see Side Lover Removal in the Frame chapter).

• Remove the junction box.

• Check conductivity of the following numbered terminals by connecting the hand tester and one 12V battery to the junction box as shown.

• If the tester does not read as specified, replace the junc­tion box.

Special Tool - Hand Tester: 57001-1394

	Te s t e r Connection	Tester Reading (Ω)		Test e r Connection	Tester Reading (Ω)
Headlight Relay	7-8	ОО	Starter Circuit Relay	9 -11	ОО
7-13	ОО	12 -13	ОО
(+) (-) 13-9	Not ∞ *	(+) (-) 13-11 (+) (-) 12 -11	∞ Not ∞ *

(*): The actual reading varies with the hand tester used. (+): Apply tester positive lead. (–): Apply tester negative lead.

Дата добавления: 2014-12-23