C Measure the rotor tip clearance with a feeler gauge - rotor marks (arrowed)

Undo the three screws (arrowed) and remove the pump cover

Non-VVT-i engines

Refitting

15 Lubricate all rotors with clean engine oil

and place them in the pump body with the marks facing in (1.3 litre engine) or out (1.6 litre engine) (see illustration 13.14c).

16 Pack the pump cavity with petroleum jelly, attach the pump cover and tighten the screws (1.6 litre engine only).

17 Lubricate the oil pressure relief valve piston with clean engine oil and reinstall the valve components in the pump body or engine block.

18 On 1.3 litre engines, apply a bead of RTV sealant to the pump body (see illustration) and locate a new O-ring in the body groove. On 1.6 litre engines, place a new gasket on the engine block (the dowel pins should hold it in place).

19 Position the pump assembly against the block and install the mounting bolts. On 1.6 litre engines, make sure that the flats on the oil pump drive rotor align with the flats on the crankshaft

(see illustration).

Дата добавления: 2014-12-23