Condenser cooling fan

Radiator cooling fan

Renewal

8 Disconnect the negative battery cable (see

Chapter 5A).

9 Disconnect the wiring connector at the fan motor.

10 Drain enough coolant to disconnect the upper radiator hose at the radiator (see

Chapter 1).

11 Unbolt the fan shroud from the radiator and lift the fan/shroud assembly from the vehicle (see illustrations).

12 Hold the fan blades and remove the fan retaining nut (and spacer, if equipped) (see illustration).

4.11a Undo the fan shroud retaining bolts	4.11b On single headlight models the fan	4.12 Undo the fan blade retaining nut
shroud is also bolted at the lower edge
(arrowed)	(left-hand lower bolt arrowed)

Cooling, heating and air conditioning systems 3•5

13 Unbolt the fan motor from the shroud (see illustration).

14 Refitting is the reverse of removal.

15 On single headlight models (pre-Oct-ober '99), a separate cooling fan for air conditioned models is located in front of the condenser. Undo the three screws and remove the radiator grille - see Chapter 11 if necessary.

16 Disconnect the wiring plug from the cooling fan motor.

17 Undo the bolt securing the fan to the slam panel brace (see illustration).

18 Prise out the upper and lower retaining pins at the right-hand edge of the fan (see illustration).

19 Undo the bolts securing the bonnet catch and bonnet slam panel centre brace, then manoeuvre the fan assembly from place (see illustration).

20 If required, undo the three fan retaining screws, then undo the screws and remove the motor.

21 Refitting is a reversal of removal.

5 Radiator and coolant reservoir -removal and refitting

Warning: Do not start this procedure until the engine is completely cool.

Дата добавления: 2014-12-23