Lubrication points and lubrication type spec

C-10

GENERAL TORQUE SPECIFICATIONS SPEC

C-9

A (Nut)	B (Bolt)	General torque specifications
		Nm
10 mm	6 mm		0,6
12 mm	8 mm		1,5
14 mm	10 mm		3,0
17 mm	12 mm		5,5
19 mm	14 mm		8,5
22 mm	16 mm		13,0

GENERAL TORQUE SPECIFICATIONS

This chart specifies torque for standard fas-

teners with ISO pitch threads. Torque spe- cifications for special components or assemblies are covered in the relevant sec- tions of the manual. To avoid warping, tigh- ten multi-fastener assemblies in a criss- cross fashion, until the specified torque is achieved. Unless otherwise specified, tor- que specifications call for clean dry thre- ads. Components should be at ambient temperature

A:Distance between flats B:Outside thread diameter

Lubrication points	Symbol
Front wheel oil seal lips (left/right)
Swing-arm oil seal lips (left/right)
Steering head pipe bearing (upper/lower)
Steering head pipe dust seal lips (upper/lower)
Tube guide (throttle grip) inner surface
Brake-lever and lever holder bolt sliding surface
Side-stand sliding surface
Centrestand sliding surface and mounting bolt
Centrestand stopper pivot shaft

LUBRICATION POINTS AND LUBRICATION TYPE SPEC

LUBRICATION POINTS AND LUBRICATION TYPE

ENGINE

Дата добавления: 2014-12-23