Maintenance Procedure. • Set the dimmer switch [A] to low beam position

Fourth Step

• Set the dimmer switch [A] to low beam position.

• Start the engine.

• The low beam headlight and license plate light should go on.

• If the low beam headlight and license plate light do not go on, inspect or replace the following item.

Headlight Low Beam Bulb (see Lighting System in the

Electrical System chapter)

License Plate Light Bulb

Headlight Fuse 10 A (see Fuses in the Electrical System

chapter)

Dimmer Switch (see Switch Inspection in the Electrical

System chapter)

Harness (see Wiring Inspection in the Electrical System

chapter)

• Set the dimmer switch to high beam position.

• The low beam [A] and high beam [B] headlights, and li­cense plate light [C] should go on.

• The high beam indicator LED [D] should go on.

• If the high beam headlight and/or high beam indicator LED, and license plate light do not go on, inspect or re­place the following item.

Headlight High Beam Bulb (see Lighting System in the

Electrical System chapter)

License Plate Light Bulb

Dimmer Switch (see Switch Inspection Electrical System

chapter)

• Turn off the engine stop switch.

• The low beam and high beam headlights, and license plate light should stay going on.

• If the headlights, license plate light and high beam indica­tor LED go off, inspect or replace the following item.

Headlights or Indicator Light (see Lighting System in the Electrical System chapter) License Plate Light Bulb

• Turn off the ignition switch.

• The headlights, license plate light and high beam indicator LED should go off.

Headlight Aiming Inspection

• Inspect the headlight beam for aiming.

• If the headlight beam points to one side rather than straight ahead, adjust the horizontal beam.

Периодический ремонт 2-37

Дата добавления: 2014-12-23