Front fork chas

J-16

7. Inspect:

• Inner tube operation

Un-smooth operation —(Disassemble and recheck

3. Install:

• Plain washer Ø NEW

• Bolt (damper rod) Ø

4. Tighten:

• Bolt (damper rod) Ø

23 Nm (2.3 m•kg)

8. Fill:

•

	Oil quantity 0.130L
Recommended oil: Fork oil SAE 20 or equivalent.

Fork oil

NOTE:

Tighten damper rod bolt Ø while holding the damper rod with a T - handle Ø and a damper rod holder Ø.

	Damper rod holder 90890 - 04084
T - handle 90890 - 01326

5. Install:

• Oil seal Ø NEW

• Retaining clip

• Dust seal

Use the fork seal driver weight Ø and the attach- ment Ø.

NOTE:

Before installing the oil seal Ø, apply lithium soap base grease onto the oil seal lips.

Adjust the retaining clip so that if fits into the outer tube groove.

CAUTION:

	Ford seal driver weight: 90890 - 01367
Attachment: 90890 - 01368

Make sure that the oil seal numbered side faces upward.

9. After filling up, slowly pump the fork up and down to distribute the fork oil.

10. Measure:

• Oil level §a

Out of specification —(Adjust.

	Oil level: 120 mm
(From the top of the inner tube fully com- pressed and without the fork spring)

NOTE:

Hold the fork in an upright position.

11. Install:

• Front fork spring Ø

• Cap

• Retaining clip

NOTE:

Install the fork spring with its smaller pitch upward Before installing the cap bolt, apply grease to the O - ring.

Temporarily tighten the cap bolt

Дата добавления: 2014-12-23