Maintenance Procedure. Complete cleaning and drying the chain within 10 minutes

Brakes

Complete cleaning and drying the chain within 10 minutes.

Any other cleaning solution such as gasoline or trichloroethylene will cause deterioration and swelling of the O-ring.

Blow the chain dry with compressed air immedi­ately after cleaning.

• Apply oil to the sides of the rollers so that oil will penetrate to the rollers and bushings. Apply the oil to the O-rings so that the O-rings will be coated with oil.

• Wipe off any excess oil.

Brake Fluid Leak (Brake Hose and Pipe) Inspection

• Apply the brake lever or pedal and inspect the brake fluid leak from the brake hoses [A] and fittings.

• If the brake fluid leaked from any position, inspect or re­place the problem part.

2-28 Периодический ремонт

Brake Hose Damage and Installation Condition Inspection

• Inspect the brake hose and fittings for deterioration,
cracks and signs of leakage.

OThe high pressure inside the brake line can cause fluid to leak [A] or the hose to burst if the line is not properly main­tained. Bend and twist the rubber hose while examining it.

• Replace the hose if any cracks [B] or bulges [C] are no­
ticed.

•Tighten any loose fittings and any banjo bolts.

Torque-Brake Hose Banjo Bolts: 34 N·m (3.5 kgf·m, 25 ft·lb)

• Inspect the brake hose routing.

+

• If any brake hose routing is incorrect, route the brake hose
according to Cable, Wire and Hose Routing Section in the
Appendix chapter.

Brake Operation Inspection

• Inspect the operation of the front and rear brake by run­ning the vehicle on the dry road.

• If the brake operation is insufficiency, inspect the brake system.

Дата добавления: 2014-12-23