Rim Runout Inspection

WARNING

Spoke Tightness Inspection

• Check whether all the spokes are uniformly tightened.

• Uniformly tighten the spokes if any spoke is loose or un­evenly tightened.

Torque -Spoke Nipple: 3.0 N·m (0.3 kgf·m, 26 in·lb)

(On and after EJ650-A3/C3): 5.1 N·m (0.52 kgf·m, 45 in·lb)

Inspect the rims.

If any spoke brakes, it should be replaced immedi­ately. A missing spoke places an additional load on the other spokes, which will eventually cause other spokes to break.

• Raise the front/rear wheel of the ground.

Special Tool - Jack: 57001-1238

•If there is any damage to the rim, replace the rim.

• Check the rim for damage or warpage.
+ I

Выход оправы (с установленной шиной) Стандарт: Осевое биение Радиальное биение Сервисный Предел: Осевое биение Радиальное биение

0.5 mm (0.02 in.) 0.8 mm (0.03 in.)

Measure the radial [A] and axial [B] rim runout by placing a dial gauge against the sides and the outer circumference of the rim, and slowly rotating the wheel.

Дата добавления: 2014-12-23