КАТЕГОРИИ: Архитектура-(3434)Астрономия-(809)Биология-(7483)Биотехнологии-(1457)Военное дело-(14632)Высокие технологии-(1363)География-(913)Геология-(1438)Государство-(451)Демография-(1065)Дом-(47672)Журналистика и СМИ-(912)Изобретательство-(14524)Иностранные языки-(4268)Информатика-(17799)Искусство-(1338)История-(13644)Компьютеры-(11121)Косметика-(55)Кулинария-(373)Культура-(8427)Лингвистика-(374)Литература-(1642)Маркетинг-(23702)Математика-(16968)Машиностроение-(1700)Медицина-(12668)Менеджмент-(24684)Механика-(15423)Науковедение-(506)Образование-(11852)Охрана труда-(3308)Педагогика-(5571)Полиграфия-(1312)Политика-(7869)Право-(5454)Приборостроение-(1369)Программирование-(2801)Производство-(97182)Промышленность-(8706)Психология-(18388)Религия-(3217)Связь-(10668)Сельское хозяйство-(299)Социология-(6455)Спорт-(42831)Строительство-(4793)Торговля-(5050)Транспорт-(2929)Туризм-(1568)Физика-(3942)Философия-(17015)Финансы-(26596)Химия-(22929)Экология-(12095)Экономика-(9961)Электроника-(8441)Электротехника-(4623)Энергетика-(12629)Юриспруденция-(1492)Ядерная техника-(1748) |
All engines
VVT-i engines B On VVT-i engines, the marks on the camshaft sprockets (arrowed) should align with the top edge of the cylinder head A Prise out the plastic fasteners at the rear of the engine cover... Non-VVT-i engines Removal Cylinder head cover A The camshaft sprocket is at TDC when the hole in the sprocket lines up with the notch in the bearing cap
located by turning the crankshaft 180° and following the firing order.
- removal and refitting
1 Undo the two nuts, prise out the two plastic fasteners, and remove the plastic cover (where fitted) over the engine (see illustrations).
2 Detach the PCV hoses from the cylinder head cover.
3 Remove the HT leads from the spark plugs, handling them by the caps, not pulling on the leads, and release them from any clips on the cylinder head cover.
4 On 1.6 litre engines, remove two bolts at the timing belt end of the cylinder head cover, then pull up the wiring harness cover and wiring (see illustration).
5 Remove the ignition coils as described in Chapter 5B.
6 Remove the cylinder head cover mounting nuts/bolts, then detach the cylinder head cover and gasket from the cylinder head (see illustrations). If the cylinder head cover isstuck to the cylinder head, bump the end with a wood block and a hammer to jar it loose. If that doesn't work, try to slip a flexible putty knife between the cylinder head and cylinder head cover to break the seal.
Caution: Don't lever at the cylinder head cover-to-cylinder head joint or damage to
Дата добавления: 2014-12-23; Просмотров: 480; Нарушение авторских прав?; Мы поможем в написании вашей работы! Нам важно ваше мнение! Был ли полезен опубликованный материал? Да | Нет |