Make sure that the brake hose is routed properly

Before tightening the axle nut, stroke the front fork several times to check for proper fork opera- tion.

FRONT WHEEL INSTALLATION

Reverse the “REMOVAL” procedure. Note the following points:

1. Lubricate:

• Front wheel axle

• Bearings

• Oil Seal (lips)

• Drive/driven gear (speedometer)

Recommended lubricant: Lithium soap base grease

2. Install

2 • Speedometer gear unit Ø

NOTE:

1 3 Make sure that the wheel hub and the speedometer gear unit are installed with the three projections Ø

meshed into the three slots Ø.

3. Install

• Front wheel

NOTE:

Make sure that the slot in the speedometer gear unit fits over the stopper on the front fork outer tube.

4. Tighten:

• Front wheel axle

• Axle nut (front wheel axle) Ø

CAUTION

s WARNING

1. Remove:

• Balancing weights

2. Set:

• Wheel (on a suitable stand)

3. Find:

• Heavy spot

************************************************************ Procedure:

a. Spin the wheel and wait for it to rest

b. Put an “X1” mark on the wheel’s bottom spot.

c. Turn the wheel so that the “X1” mark is 90º up.

d. Release the wheel and wait for it to rest. Put and “X2” mark on the wheel’s bottom spot

e. Repeat the above b., c., and d. several times until all marks come to the same spot.

f. This spot is the wheel’s heavy spot “X”

************************************************************

4. Adjust:

• Wheel static balance

************************************************************ Adjusting steps:

• Install a balancing weight Ø on the rim exactly

opposite to the heavy spot “X”.

NOTE:

Start with the smallest weight.

• Turn the wheel so that the heavy spot is 90º up.

• Check that the heavy spot is at rest there. If not, try another weight until the wheel is balanced.

************************************************************

Дата добавления: 2014-12-23