When pushing the calliper piston into the brake calliper, the brake fluid level in the reservoir incre- ases

MASTER CYLINDER

FRONT BRAKE CHAS

J-7

FRONT BRAKE CHAS

FRONT BRAKE CHAS

J-6

FRONT BRAKE

BRAKE PAD

6 Nm (0,6 m•kg)

23 Nm (2,3 m•kg)

Order	Job name/Part name	Quantity	Remarks
	Brake pad removal		Remove the parts in order
Calliper support bolt
	Brake pad
Reverse the removal procedure for
installation.

BRAKE PAD REPLACEMENT

NOTE:

It is not necessary to disassemble the brake calliper and brake hose to replace the brake pads.

1. Remove:

• Bolt (Calliper support bolt) Ø

Move the direction brake calliper to the arrow mark

2. Remove:

• Brake pads

NOTE:

Install new brake pad springs when the brake pads have to be replaced.

Replace the brake pads as a set if either is found to

2 1 bewornto the wear limit.

3. Push the calliper piston into the brake calliper by finger.

CAUTION:

4. Install:

2 • Brake pad Ø

Order	Job name/Part name Qu	ntity	Remarks
	Master cylinder removal Drain the brake fluid   Front grip Brake lever Brake switch Union bolt Plain washer Brake hose Master cylinder bracket Master cylinder			Remove the parts in order Refer to “BRAKE FLUID REPLACE- MENT section in Chapter 3.
		Refer to “MASTER CYLINDER. INSTALLATION” section in Chapter 3
	Reverse the removal procedure for installation.

Install the brake pad, and move the brake calliper in the direction of the arrow.

5. Install: a

•Bolts (calliper support bolt)

1 23 Nm (2.3 m•kg)

6. Inspect:

• Brake fluid level

Refer to “BRAKE FLUID LEVEL INSPECTION”

section in CHAPTER 3.

7. Check:

• Brake lever operation

Soft spongy feeling, bleed the brake system. Refer to “AIR BLEEDING (HYDRAULIC BRAKE SYSTEM”) in CHAPTER 3.

Дата добавления: 2014-12-23